However you will also need to install the K+D CAN utility, this allows you the ability to switch it from a K CAN device for pre-2007 cars (see list above) to a DCAN cable. This cable is a USB enabled device, again you will need to install the USB to serial drivers. This does 2001-on cars right up to & including 2011 cars (may be limited by the hookie software for cars after June 2008 on a diminishing basis as the car gets newer). With the USB K+D CAN type cables there are a few installation steps, drivers & a little software that you need to make them work properly. This is the current most used cable for INPA. Here list all possible INPA hardware cables.įirst of all, INPA software can be downloaded free here:īmw inpa software freedown and setup instructionīMW INPA K+DCAN cable with FT232RL chip Ediabas ADS/OBD interface Non-ADS Ediabas OBDII RS232 interface INPA + 140+2.01+2.10 4 in 1 BMW Scanner Carsoft 6.5 interface BMW ICOM A2+B+C emulator Many FTDI FT232RL based cables can be modified to work with INPA software for BMW diagnosis.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |